Back to the main page Back to category Power Boats
boat details
Sea Serpent 20
Estimated price for orientation: 692 $
Category: Power Boats
Class:
Description Condition: Used: An item that has been previously used. See the seller’s listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition
This boat was built by Green Bay Fibre Products in Canada as a leisure/fishing boat. It is a very sturdy construction with a 4x2 timber frame, fibre glass finish and powered by a 90Hp 3Cyl Mariner power trim outboard. It has been used on the non tidal Thames for the last 10 years. However, during last winter the auto bilge failed causing the aft end to submerge. The boat was recovered and the engine has been 'jump started' since. The only structural damage is where a rear mooring cleat was ripped from the deck, this requires a fibre glass repair. Also requires new battery and probably starter motor - can not vouch for what engine components may need replacing but it has been a solid runner until this incident. Basically this boat is now a clean up and refurb project. The last 2 photos show how the boat looked before the incident.The boat is sold as shown with no trailer. The buyer will be responsible for collecting from dry mooring as shown and the onward transport. You are welcome to ask any questions or view at Marlow, Bucks.
Description
| Condition: | Used: An item that has been previously used. See the seller’s listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition |
This boat was built by Green Bay Fibre Products in Canada as a leisure/fishing boat. It is a very sturdy construction with a 4x2 timber frame, fibre glass finish and powered by a 90Hp 3Cyl Mariner power trim outboard. It has been used on the non tidal Thames for the last 10 years. However, during last winter the auto bilge failed causing the aft end to submerge. The boat was recovered and the engine has been 'jump started' since. The only structural damage is where a rear mooring cleat was ripped from the deck, this requires a fibre glass repair. Also requires new battery and probably starter motor - can not vouch for what engine components may need replacing but it has been a solid runner until this incident. Basically this boat is now a clean up and refurb project. The last 2 photos show how the boat looked before the incident.
The boat is sold as shown with no trailer. The buyer will be responsible for collecting from dry mooring as shown and the onward transport. You are welcome to ask any questions or view at Marlow, Bucks.