The design is a Hustler 30 – Cruising Dinette VersionMoulded 1972 but not launched until 2007.Length 30 feet or 9.14 metresBeam 2.97 MetresDraft 1.4 MetresAir draft 13.8 MetresDisplacement 3.450 kgCast Iron Keel (1460kg)Storage on Mooring (Kept afloat and available for viewing In Oban, Argyll)Engine Volvo Penta 2020, Single folding propeller.Fuel tank (Diesel) 45 LitresWater Tank 45 LitresLast survey 29/03/20115 Berths consisting of 1 double and 3 singlesOven, grill and hob (Gas, Plastimo Neptune 2000)SinkSea ToiletNon smokers use onlyEberspacher D1LC 1800w Diesel Heater12 volt (Two battery system)Wired for shore powerLewmar Winches (x6)Mainsail – Roller Boom, Sail in Good/Fair ConditionGenoa Foresail (Sail Good/Fair) – Furlex Furling Gear excellent condition.Spinnaker (Good/Fair)GPS/Sat Nav and repeaters in cockpit (Clipper repeater)Plotter in CockpitSounder (Seafarer) Repeater in cockpitVHF DSC RadioThrough Hull Log. (Airmar)Anchor and Chain. This vessel has had three owners since its mould in 1972.  It was kept in dry storage until its launch in 2007.  It has been finished to a very high standard and has plenty of room below decks for storage as well as large cockpit lockers.  There is plenty of standing room below decks. She has been well maintained by all her owners and much spent on her to keep her to her original standard upon launch in 2007.  This has been a non-smoking boat.  At present she is afloat in Oban in Argyll and can be viewed at any time.  The last survey was on 2011 and a copy can be forwarded to serious enquirers upon request. The boat is for sale as ‘ready to go’ and can be sailed away upon purchase.  It is a very sea worthy Don Pye design, moulded by Tyler and has excellent sea going capabilities.  The vessel cruises at 5 knots approx.  Although we have recorded 8.1 knots through the water speed earlier this year. The hull was antifouled and checked over in May this year.Any questions please contact seller.